Solution home SynetoOS 5 Manual

Installation

**Start Here
To install a HYPER appliance that runs SynetoOS 5 please follow the steps below: Prerequisites - what is needed to perform the installation  SynetoOS ...
**Prerequisites
Following requirements are needed to successfully install and operate HYPER appliances running SynetoOS 5 Monitor and keyboard connected to the applian...
*Physically connect the Appliance(s) to the Network
Connect the HYPER appliance to the local network using at least two Ethernet UTP cables: one for the IPMI one for the hypervisor  HYPER Edge G2 ...
*SynetoOS 5 - Endpoints and Ports
In order to allow remote support and management, VMWare integration and snapshot replication, SynetoOS uses a set of TCP ports. Inbound Ports Synet...
*Configure and Connect to IPMI / Out-of-band Management
IPMI means Intelligent Platform Management Interface. It is a web based interface that allows, once configured, remote out-of-band management of the hardwar...
*Configure and Connect to the ESXi Hypervisor
When configuring a Syneto HYPER appliance you are also required to configure the ESXi hypervisor running on the appliance. There are two scenarios: Acti...
**SynetoOS 5 - Virtual Machine Console
SynetoOS 5 has a new virtual machine console interface. The virtual machine console show the status of core SynetoOS services, enables IP addressing config...
*SynetoOS 5 - Quick Setup
The Quick Setup web interface is used to configure every Syneto HYPER appliance on first use. To successfully configure the appliance, please make sure the ...
*SynetoOS 5 - Login and Activation
Syneto HYPER appliances require activation when installing the first time or when performing a clean re-install. Login Using your preferred browser,...
*SynetoOS 5 - Connect to Local Hypervisor
SynetoOS5 is not connected anymore out-of-the-box to the hypervisor that is running on the physical appliance.  Users are required to manually configure an...